Search found 24 matches

I'm using the IDE: PCWHD-IDE
Version 4.141 and neither of the wizards will run.

Anyone else experienced this problem?
Any advice appreciated.

Regards Bill Legge

Thanks Ttelmah,
I'm working on using the get_string function in input.c as you suggested but when I compile it I get these error messages:

*** Error 12 "C:\Program Files\PICC\PICC WVL Code\PI ...

I'm trying to get some code to work:
1. Read a string from the RS232 UART.
2. Use TIMEOUT to keep going if there is no input.
The following code works OK without TIMEOUT but not as below:

////// ...

Thank you. Working fine with no changes on:

Mikroelektronika BIGPIC5 board
With PIC18F8722 at 4X10MHz

Regards Bill Legge

PCM

Thank you - that worked a treat.

void WaitForShutUp(void)
{
int8 status;

do{
i2c_start();
i2c_write(0xC4); // Device address - Writ ...

Thanks, I have got it working. The following code gets the SP03 to play a test message and a pre-recorded message. A fixed delay is used to wait till the first is done:

////////////////////////// ...

Thanks PCM

I have tried it with the first hardware I2C and the '12c_write(0x00)' to select the command register but no joy.
I will try the software on your link.

Thanks for your advice

regar ...

I'm trying to drive the SP03 text-to-speech module from robotparts.com.au using the I2C method - and having no luck.
I do have 4.7k to Vcc on both SDA and SCL lines.

1. The module works OK with th ...

I have a problem using the search tool:

1. Define the search.
2. Get a display of matching topics
3. Open and read one of them, and
4. Then want to read a different one of the selection
... and ...

I'm about a month into 'C' and the some of the best resources I've found:

1. This forum, particularly the 'code' section where I've been able to download other members code and pick it apart to lea ...

I would welcome comments/arguements on the business of using Manchester code for radio links. I don't think it is generally necessary because:

1. Most (I would guess very nearly all) 433MHz type ...

Thanks for your reply.

I will try the 'ERRORS' but think that it's my code at fault and not the RS232 link/comms. I've used RS232 for a few years now (but not with a C compiler) and not come acros ...

I've been learning/testing the get/gets and put/puts functions with the following code:

#include <main.h>
#use rs232(UART1,BAUD=2400) // default, 8_bits, no parity
#define HEARTB ...

I've written a function to set one of the hardware PWM modules
to a desired frequency and pulse duration.

Uses a 8MHz Xtal so one cycle=0.25uS
And timer2 in 32_bit mode, the code is:

// MCU is ...

I'm missing something basic in the CCS IDE:

How to add/delete files to a project?

With MPLAB, one just adds or deletes using:
1. The item in the 'Project" drop down list.
2. Or, right-cli ...