Search found 7 matches

hi everyone,

This is my final contributed version of the pic16f1507 CLC2 setup as 2-Input D-FLIP-FLOP which is configured as frequency divider.

Signal generator to pin RC3 28khz and output from ...

That is only really an expansion of what is in the data sheet.

Key thing is to draw out the actual logic you want.

The CCS approach follows exactly the data sheet description. All they omit to t ...

If you can't get the CLC stuff to run right, just program the PIC using CCS C ! 2 decades ago I used a PIC16C84 as a 'PLC' in some custom kit to foil( well slow down) the reverse engineers.
Microchip ...

I hope someone can provide a solution using CCS PIC C to create a working 2 input D- Flip-Flop.
Only the assembly version works as shown previously.

You do mean working in hardware, not in Prote ...

I'd have thought CCS would have an example for the 'CLC' PICs but my compiler versions are rather old.....

If not, ask and they will probably do one for the next release ?

Jay

hi temtronic,
...

I have a question. This stuff at the bottom, such as:
//extracted from MPLABX for PIC16F1507 using CLC2

// CLC2POL = 0x00;

// LC2D2S LC2OUT; LC2D1S CLCIN0;
// CLC2SEL0 = 0x50;
...

Hi,

I have problem getting 2 input D- Flip-Flop configured as frequency divider on 16F1507 and 12F1501 in Proteus 8.2 using CCS which is not working very well.

However using MPLABX XC8 i was ab ...