Search found 14 matches

I just want to contribute by saying that you could use software to faster increment of the variable until it is equal the targeted value of say 25.1
while(temp_global<25.1){
temp_glo ...

yes the edge can be changed within the interrupt routine, but just be sure that you disable the specific interrupt within the routine before changing the edge and re enable it before leaving the inter ...

Hello Gabriel, depending on the way the press button is connected to your mcu the outcome of your code will be different. For instance on the PICDEM 2 PLUS demo board the input is pull up, in that cas ...

Somebody out there please help. I had been trying to decode Sony TV remote control all to no avail. I have read so much on this on the internet, but the theory seem far different from the practice. I ...

Thanks a lot PCM PROGRAMMER you solved my problems.

Please somebody tell me, does ccs have any function to check if interrupt flag bit is set? If yes what is it?

Which of these is correct: clear_interrupt(INTF) or clear_interrupt(INT_EXT) ?
Both wi ...

YOU DELAYED FOR 100ms for the unit digit. where is your delay for tenth digit?

Hello all.
I want to save the ccp1 captured value to internal eeprom. The captured value is in the vicinity of 24000. I tried writing and reading from the eeprom, but all I could read was 255. In fac ...

Check the include file (the key pad driver) if K is not declared in there then declare K as a character variable in your main code. e.g
Char k;
just before your functions declarations.

I have learned PIC MCU programing to the level that want to make a digital read out from my analog tuner world receiver. I will pick the signal from the mixer stage and input onto a frequency counter. ...

Hello Stock2. All that you need do is declare an array of the digits 0 - 9 for example
char dig_map[10] = {3f, 0x06,0x5b,4f.............0x6f};

then

void display() ...

According to temtronic it would be best if you send your code.
however you be sure that all variables you using for your formular are globally declared as float or if you are simply wanting to displa ...

Hello Douglas.
The code you forwarded to me worked, but i could comprehend the code.
I observed that the origin (0,0) is at the far right side instead of left side of the glcd. Again the circle coul ...

I am very new to mcu programming. I will appreciate if anyone could tell me why the ccs GRAPHICS.C driver in PCM compiler displays an elliptical shape instead of a true circle. I have compiled the ccs ...