Search found 25 matches

How can I force the floating variables to be displayed in the format of say 00.00 for example ?

I am trying to send some variables down the RS232, some of which are integers and some of which are f ...

I have written some code which calculates six int16 values to be loaded into CCP1.

Say for example, my code calculates the following values...

A_RisingEdge=12500;
C_FallingEdge=31250;
B_Ris ...

Thanks Mark,

I have written code to calculate the CCP1 interrupts for the rising and falling edges on each phase.

Using a period which gives a Timer1 measurement of 37,500 (60ms period) and a de ...

Please help.... I'm so near yet so far !!

I have a squarewave input of a variable frequency from 15Hz to 30Hz.

I want 3 outputs to fire the gates of 3 triacs.

These outputs need to be phase s ...

I copied and pasted your code into my version of CCS and it compiled without any errors.

So it must be something to do with your version or installation of CCS ?

Are you able to get an update of ...

jump_to_isr is a function.

for some reason when you are compiling your code the function is not defined or recognised by the compiler.

what version of compiler are you using ?

in CCS go to 'H ...

I have recently used the bootloader that comes with the examples for the CCS compiler called "ex_bootloader.c"

Have you got this example ?

By pulling a pin low when you reset the PIC, the bootlo ...

Ive just found out.... I can read the eeprom but not write to it.

So its as if its protected ?

But I have set the config for it not to be write protected using the statement....

#FUSES NOWRTD ...

I am emulating a PIC18F452 on an ICE2000 (using the PCM18XH2 processor module).

However, the commands write_eeprom & read_eeprom do not to work ?

When I use a breakpoint on the statement... ...

I am trying to use the 'pin' parameter as a variable in the command output_bit.

e.g output_bit (pin, value)

I want the 'pin' parameter to be a variable so that the output bit depends on the val ...

I have blown a PIC18F452 with the ex_bootloader.c example program supplied with CCS.

This works fine and I have successfully downloaded a simple application program via the RS232 which flashes an L ...

I am using a PIC16F877A which I need to reprogram whilst the PIC remains in circuit.

Which would be the best method to use, the bootloader method or the ICSP method ?

I want to connect my circui ...

Store the arrays in ROM.
Copy an array into RAM buffer and pass a pointer to your function.

Thanks Mark,

I'm trying to do what you suggested.

I've now stored all my arrays of data in ROM (pr ...

I've been using arrays which I have been storing RAM.

Below is an example of how I initialised my arrays in RAM...

int ShiftSchedCold_1to2[2][4] = {{20,20,52,52} ...

I am using,

- a PIC16F874A which has 192 bytes of RAM
- a PIC16F877A which has 368 bytes of RAM

The PIC16F877A is the same as the PIC16F874A but has twice the amount of ROM and EEPROM and almos ...