Search found 9 matches

No i am using CCS PIC C, but i do have the mplab 8 plugin installed. Could that cause the problems.

I am just copying the same program posted online and just compiling and it is finding an error in ...

PCM,

Thank you for all your help, i am having some problems trying to compile the sample program you directed me to earlier, even when i copy the same program using the microcontroller it gives me ...

Thank you PCM.

But i have a question here, i cannot use a trimpot in the project that this servo is intended for.

I am basically trying to take in a digital compass string and based on that bear ...

PCM and RLScott,

Thank you very much.

Yes you are right i need to vary the on and off time just changing the duty cycle is not enough.

I am currently trying to to use the Servos.c file in PIC ...

Thank you PCM for your help.

I will only be using one Servo, but the code helps, its a good example. I am trying to control the servo using a digital compass ($HCHDG string) the heading from the di ...

I am trying to control my DC motor using an electronic speed controller which controls the DC motor with a 50Hz PWM frequency. But i believe that with 8Mhz clock (Internal clock) the lowest frequency ...

Thank you everyone, i wanted to know does it matter if you use CCP1 or CCP2 because i want control two devices with PWM.

here is the updated code, do you guys see any problems.

#include < ...

if i use CCP1 for the motor i need to use CCP2 for the Servo, in that case what settings do i use.

I am newbie to microcontroller programming i am using the CCS PIC C 4.057.

Microcontroller PIC18F4550

Using the Project Wizard option, i am trying to setup a internal oscillator to run at 8MHz. ...