Search found 12 matches

I'll do that right now, Thanks

Hi Guys,
My compiler etc I believe is all fine but I, and others based on a google search, am having problems getting the MTCH6301 (Microchip capacitive touch screen interface) to work. The datasheet ...

Hi,
I've noticed that a few flash chips e.g. W25Q16BVSSIG, M25PX16-VMN6TP now run 2 and even dual X 2 SPI's via doubling up the pin directions e.g. making SDI and SDO bidirectional unstead of unidire ...

Me to, I've just started a new project and desperately need to get the CAN up and running for an dsPIC30F4013

Hi,
Could anyone please tell me how to setup the dspic33FJ128GP310 to run at 40mhz with a 10mhz crystal. Maybe I'm just dizzy but it runs perfect on the internal osc, but as soon as I try to switch i ...

thanks Ttelmah for that code, I've put it in and after I sorted a little mistake on my part Confused

it is working brilliantly, your a genius, thanks for that

thanks for your efforts. I need to measure from 16hz to 600hz. I have changed my code to the previously mentioned code above...

#int_ccp4
void rpm_isr(void) {
disable_interrupts(int_timer1);
...

Thanks heaps for the feedback, I'll try that coding change this morning. I am running 10mhz + PLL, so 40mhz and I am using a high priority on CCP4

I was running it today at 322hz and 150hz. Voltage is 5V. I'm running the input signal from a tti function generators TTL output at 50% duty and have also tried it from the 600ohm and 50ohm outputs at ...

Oh well, I'll try it again, it was just that it was unsteady at higher frequencies,
Thanks

18F8722 and Version 3.249

Hi,
Can anyone out there show me where I am going wrong with this. In the PIC sim it works perfect but on the bench, occasionally the MSB goes walkies and I just end up with an RPM based on the LSB. ...