 |
 |
 FAQ Forum Help Official CCS Support  Search
 Register
 Profile  Log in to check your private messages  Log in
|
CCS does not monitor this forum on a regular basis. Please do not post bug reports on this forum. Send them to CCS Technical Support |
| Search found 3 matches |
| Author | Message |
|---|---|
 Topic: bad CAN bit timing |
|
| Thom Replies: 2 Views: 5186 |
 Forum: General CCS C Discussion Posted: Wed Jul 06, 2011 3:21 am Subject: bad CAN bit timing |
| Thanks for your answer
Most device with CAN are running at 20MHz. I'm trying to run at this frequency in order to see if I add 2 Tq (so 10 Tq instead 8) give a good bit timing |
|
| Topic: bad CAN bit timing |
|
| Thom Replies: 2 Views: 5186 |
Forum: General CCS C Discussion Posted: Tue Jul 05, 2011 3:54 am Subject: bad CAN bit timing |
| Hi everybody
I actually developed a CAN bus interface which is running with an external 16MHz (100ppm) XO clock. I want a can bitrate up to 1Mbit/s. I have a PIC18F45K80 and CAN CCS library. I confi ... |
|
| Topic: 18F45K80 switch oscillator |
|
| Thom Replies: 1 Views: 4657 |
Forum: General CCS C Discussion Posted: Thu Jun 30, 2011 3:44 am Subject: 18F45K80 switch oscillator |
| Hello,
Can anybody help me? I have a 18F45K80 with an external XO (16MHz) which have an enable pin. I wish to switch to internal oscillator (31 KHz) and drive low the enable pin to shutdown the e ... |
|
All times are GMT - 6 Hours |
Powered by phpBB © 2001, 2005 phpBB Group