Search found 17 matches

Neutone,
I am using MPLAB 7.2 with ICD2 and a 18F458. Valid Fuses is not part of the View dropdown. They are:
1.Disassembly Listing
2.Hardware Stack
3.Program Memory
4.File Registers
5.EEPROM
...

asmallri,
Thanks, and I got all that. It still isn't real clear what they are. Take HS XT RC or LP, the data sheet for the 458 says they are oscillators. The header file says it's a fuse. So it's a ...

Got it..................
Just FYI. I have been playing around with a few things and noticed something. First I changed to RA0 then RA1 and still saw the same 12Hz pulse on these ports. Then I changed ...

PCM,
Actually I did that, I just forgot to mention it. It is a 20Mhz oscillator so I felt the delay directive was correct. I played with the code a little and duplicated the delay and I still have a ...

Hum,
Got it and I think it is the fuse directive, but I have not confirmed that. I also need to play around with timing a little as I am getting a 12Hz pulse coming out. It should be 2Hz.
Tim

Mr Wizard,
Got it, but I cannot see "much" difference in the code. I know I had a crappy loop, but I am looking at the fuse compiler directive. Must be one of the fields.
Thanks again
Tim Moody

Just FYI, I am thinking maybe the LED is blinking ten times and I am missing it due to timing. Maybe it is happening faster than I can see.
Tim

PCM,
Thanks for all you help.
I read thru the link and did what you said there. Everything appeared good, but when I powered down the SBC and unplugged the PGM06, and powered it back up, I have a so ...

OK, I downloaded and installed 7.20. Rebooted and everything is done. I run MPLab 7.2, open my project, compile successfully, and I get the following. The target is still not in debug mode. Also I sti ...

Opps. Let me try the coorect installation. What I downloaded before was the "Components Download" I am trying the full zipped version
Tim

OK, I went from bad to worse. I went to install MPLab 7.20 as suggested. The install suggests you un-install previous version of MPLab, so I did. The install of 7.20 crashed and burned with the error, ...

One thing I cannot find that has been mentioned several times is the Configuration Bits setting of Background Debug. I cannot find that setting. I am using MPLAB 7.00 and CCS C version 3.234, and a PI ...

PCM,
I thought this was different enough(get the SBC44 running versus toggling an LED with it) to start a new thread, sorry. I read thru the sugested links and I am doing everything correctly(well no ...

This has to be a simple newbie mistake
OK, I have the SBC44B with a 18F458, ICD2 and PGM06 cable. I can connect to the SBC44B. I have an LED and 330ohm resistor from B0 to GND. The LED will light up ...

Guess I should have been a little clearer. I got the SBC44B yesterday, and I also have a MPlab ICD2, PGM06, and the CCS C compiler. Since I am just starting out with the PIC micros there are a few thi ...