Search found 16 matches

Hello all,
dsPIC33EP128MC506, CCS v5.070
Drivers: can-pic24.c and can-pic24.h

My code sends and receives messages. There is no problem. But i want to use FIFO features. There is not lots of infor ...

I understand what you mean. But i'm confused about arrays. Because, it is two dimension array and there are too many pieces same struct. So, how the two register share the same register position.

R ...

The data position at the can_rstack is always changing. So, i don't understand how can we use unions.
Is it possible to give an example.

Regards,

Hi again,
I changed the MDO3000 trigger source to CanBus and it triggers on Error Frame. And in single mode, it doesn't catch any signal. Very Happy

To be honest, I'm not sure that is my problem cau ...

Hi,
Thank you for your reply. I'm attaching my circuit diagram.
http://i.hizliresim.com/62J01W.pngAre they affect to the performance?

I remove the LED's. After that i get the following measuremen ...

Hi,
I have got a 5 nodes which are communicating through CanBus at 62.5kbps. I don't write any code for error handling and after around 8-10 hours (sometimes after 24 hours) one or more nodes doesn't ...

Hi,
Does can-18F4580.c and can-mcp251x.c library run at the same time?

Regards,
ZD

Hi everybody again,
I found the answer. It can be done by memcpy command.

memcpy(&can_rstack[0][0], &rx_stat, sizeof(rx_stat));
memcpy(&tx_stat, ...

Hi to all,
How can i put/get structs into/from arrays?

For example struct and array definitions are like that:

struct rx_stat {
int1 err_ovfl; // buffer overflow
unsigned ...

Hi again,
Thank you very much. As you told me, overflow and #int_canrx1 interrupt occurred and i didn't handle it.
I wrote the #int_canrx1 interrupt which is completely same code with #int_canrx0. A ...

It is little bit confused. May be it is caused from my English. Sorry. I try to explain it to you.

At first, i tried some values on MBTime software to learn it. May be 12 quanta remain from the old ...

I'm using the default values right now. It works 125K @20MHz crystal. But now, i'm using 10MHz crystal and my baud rate is 62,5K. I can listen the bus with Kvaser CanBus monitor with 62,5K setting. So ...

Hi again.
I think, i found something.
My baudrate is 62,5K. (All settings are at the default values and I'm using 10MHz crystal). That node receives a message every 100ms. So, i didn't suspect anyth ...

Hi,
Thanks for your reply.
After power up the system, it receives the datas for example 20 seconds. (This time is not exactly 20 sec. It is changing. Sometimes it is longer than 20 sec, sometimes sh ...

Hi,
I'm working on develeoping a canbus system. My node is listening the bus and send some data's every 100ms.
And i have got a run led which is blinking every 1000ms if it receives a data within 1 ...