Search found 6 matches

The problem was fixed using:
setup_compare(1, COMPARE_PWM_EDGE | COMPARE_TIMER2 | COMPARE_TRIG_SYNC_TIMER2);

The CCS support asked me to add COMPARE_TRIG_SYNC_TIMER2 and it works fine!

...

Hello,

I'm facing some troubles to put PWM module of PIC24EP512GU810 to work: it works fine, but I can't change its frequency!!

Here is the code:

#include <24EP512GU810.h>
#fuses HS,NO ...

It is likely CCS isn't ready for this chip. I never could get the CCS debugger to work with this chip even with a simple flash a led test project. It is is a bit cumbersome to get this chip oscillatin ...

Doing some tests I noticed that after I2C stops working, which occur after a reset condition, I2C only starts working again after a new power up. It seems to be impossible to put I2C working again wit ...

First, try enabling BROWNOUT in the fuses. There is an erratum for this chip, which _requires_ this to be set....
Might be your problem.

Come back if this doesn't improve things.

Best Wishes
...

Hello,

My name is Alex and I'm developing a firmware for PIC24EP512GU810 using PCD compiler from CCS.

I'm facing some troubles with I2C using PCD compiler: my code works fine, but when I reset t ...