Search found 11 matches

i tried with mplab x and ccs compiler all work, i can use 3 break point,
anybody know why ccs ide not allow me to put more that one break point ?

find solution, mplabx asked me to make update after update and restarted mplabx all work

Hi, I used my ccs compiler with ccs ide (work fine) but now I like to try ccs compile with mplabx. I see a video and I make all same but get always error when I try to complie my c file.

CLEAN SUCC ...

according to datasheet page 62 note 4:
4: When the device frequency is greater than 1 MHz, the FRC clock source is only recommended if the
conversion will be performed during Sleep.

them yo have ...

according to datasheet page 62 note 4:
4: When the device frequency is greater than 1 MHz, the FRC clock source is only recommended if the
conversion will be performed during Sleep.

them yo have ...

try

#include <12F683.h>

#define ACT PIN_A5
#define IN PIN_A3 //Main Input

#use delay(clock = 4000000)
#fuses INTRC_IO,NOWDT,NOPROTECT,NOMCLR

//time 1
int result; ...

try:

//time 1
int result;

void Time(void)
{

set_adc_channel(0); //output to port A0
delay_us(10);
result = read_adc();

for(int i = 0; i < result; i++)
{
delay_ms(12 ...

sorry not need raference if you not use vref
setup_adc_ports(sAN0 | sAN1); //read port A0 and A1 analog input

is ok because
VSS_VDD is 0x0000
them it is by default.

you Don't use the delay_us(10) at right moment, you need to wait after change channel not after read, and you frotgot to indicate the reference.

like this:
setup_adc(ADC_CLOCK_INTERNAL); // adc in ...

Hi, is it posible to have more that one break point with pic16f1788, icd3, ide ccs interface 5.070.
according with this microchip page my chip should be have 3 hw breakpoint
http://ww1.microchip.com ...

Hello, i try to program a pic16lf1786 and i get always error when i write the chip. I tried with a 16f1786 successfully them i just change the chip from an F to an LF version of chip. I made example p ...