Search found 10 matches

I'm trying to enable bi-dir communication between XBEE module and PIC24FJ256GB406. it works fine with several others component (PIC16 and PIC18) but cannot make it work with PIC24FJ. With the PIC24FJ2 ...

The issue was linked to the version of the compiler I used, which were not generated the appropriate set of instructions. I upgraded to the latest version (5.066), with same configuration and same boa ...

Could you share the Fuses configuration as you mentioned you successfully make it work ?
I found out today that there's a message on CCSLoad indicating that PCI25FJ256GB406 is not Yet supported.

C ...

I reported a false positive .. actually I've been able to program the PIC twice but some reason I'm still trying to determine it doesn't work anymore. I will try tomorrow with a new hardware in order ...

Hi Gang,

I finally make it work. The problem was related to default FUSES Configuration. By the default, the option 'WDT clock source is determined by WDTCLK configuration Fuses' is selected when y ...

I just tried with a newer release 5.034 and Firmware 3.18 and there's no improvement.

so, what is the conclusion here ? How to we get this to work with PIC24 ?
Anybody from CCS could shim in ?

Thanks for the suggestion. Actually, I already tried this before and wasn't able to find significant issue under diagnostic. The PIC is well recognized, I can read the Target Device ID and all PIN loo ...

I notice few inconsistencies between the PIC24FJ256GB406 data-sheet and the PIC-24 bit Wizard, specifically around UART Setup. For example, data sheet indicates for UART5 that TX is on RD1 and RX is ...

Hi Folks,
I'm trying to use CCS version 5.061 along with ICD-U64 to compile very simple software on PIC24FJ256BG406 and I cannot make it work. The software is actually pretty simple, just a dummy loo ...