 |
 |
 FAQ Forum Help Official CCS Support  Search
 Register
 Profile  Log in to check your private messages  Log in
|
CCS does not monitor this forum on a regular basis. Please do not post bug reports on this forum. Send them to CCS Technical Support |
| Search found 5 matches |
| Author | Message |
|---|---|
 Topic: ICD-U40 : Target not recognized |
|
| dcclark Replies: 2 Views: 28059 |
 Forum: CCS ICD / Mach X / Load-n-Go Posted: Mon Mar 01, 2010 1:49 pm Subject: ICD-U40 : Target not recognized |
| Make sure the RJ11 cable connector is seated firmly in the ICD. I have had this problem at least twice. | |
| Topic: Correct way to I/O |
|
| dcclark Replies: 5 Views: 5447 |
Forum: General CCS C Discussion Posted: Thu Apr 09, 2009 5:22 am Subject: Re Correct I/O |
| And of course my CCS PCWHD compiler complained. The code should be thusly: output_j((input_j() & 0xF8) | (buffer[2] & 0x7));
Thanks again. |
|
| Topic: Correct way to I/O |
|
| dcclark Replies: 5 Views: 5447 |
Forum: General CCS C Discussion Posted: Thu Apr 09, 2009 5:06 am Subject: Re: and of course there is ...... |
| output_J( ( input_j()&F8) | ( buffer
Thanks. By now it should be perfectly obvious to the most casual observer that I am transitioning from BASIC to C. Thanks again Asmboy, now that is elega ... |
|
| Topic: Correct way to I/O |
|
| dcclark Replies: 5 Views: 5447 |
Forum: General CCS C Discussion Posted: Wed Apr 08, 2009 10:13 am Subject: Correct way to I/O |
Thanks Mr. Guest. That is one of those "Why didn't I think of that?"  |
|
| Topic: Correct way to I/O |
|
| dcclark Replies: 5 Views: 5447 |
Forum: General CCS C Discussion Posted: Wed Apr 08, 2009 5:44 am Subject: Correct way to I/O |
| I wish to preserve the state of all but pins 0 - 2 of port J and then write a variable to those pins. I did the following:
Int8 b; b = (input_j () & F8); output_j (b | buffe ... |
|
All times are GMT - 6 Hours |
Powered by phpBB © 2001, 2005 phpBB Group