 |
 |
 FAQ Forum Help Official CCS Support  Search
 Register
 Profile  Log in to check your private messages  Log in
|
CCS does not monitor this forum on a regular basis. Please do not post bug reports on this forum. Send them to CCS Technical Support |
| Search found 5 matches |
| Author | Message |
|---|---|
 Topic: Switching I2C Master to Slave ..possible? |
|
| facosta.ie Replies: 9 Views: 23636 |
 Forum: General CCS C Discussion Posted: Fri Dec 02, 2016 5:14 pm Subject: Switching I2C Master to Slave ..possible? |
| http://www.ccsinfo.com/forum/viewtopic.php?p=208613#208613
I had a problem like this, and this post maybe can help if your problem is still waiting for an answer. Regards |
|
| Topic: Switch from Slave to Master in I2C during execution. |
|
| facosta.ie Replies: 8 Views: 16056 |
Forum: General CCS C Discussion Posted: Wed Nov 30, 2016 12:25 pm Subject: Switch from Slave to Master in I2C during execution. |
| Thank you again for your help Ttelmah, I think that the control line is what I need to sync correctly the devices and avoid collisions.
I'll test the complete system and will tell you the results. ... |
|
| Topic: Switch from Slave to Master in I2C during execution. |
|
| facosta.ie Replies: 8 Views: 16056 |
Forum: General CCS C Discussion Posted: Wed Nov 30, 2016 10:33 am Subject: Switch from Slave to Master in I2C during execution. |
| Thanks for your answers, Ttelmah and jeremiah with the I2C_init() instruction was enough to enable and disable one or another, it works fine.
I was testing the clk pin(C3), for enable the master a ... |
|
| Topic: Switch from Slave to Master in I2C during execution. |
|
| facosta.ie Replies: 8 Views: 16056 |
Forum: General CCS C Discussion Posted: Tue Nov 29, 2016 5:09 pm Subject: Switch from Slave to Master in I2C during execution. |
| Slave works ok, but master is not working, I use the Slave Stream in the interrupt and the Master Stream when I want to read another Slave, any suggestion?
P.S when I quit the Slave USE the mast ... |
|
| Topic: Switch from Slave to Master in I2C during execution. |
|
| facosta.ie Replies: 8 Views: 16056 |
Forum: General CCS C Discussion Posted: Tue Nov 29, 2016 12:35 pm Subject: Switch from Slave to Master in I2C during execution. |
| Hi, I'm trying to change a PIC18F25k80 from slave to master and vice versa during the program execution, is this posible?
My PIC works fine as master and as Slave individualy using the instructions ... |
|
All times are GMT - 6 Hours |
Powered by phpBB © 2001, 2005 phpBB Group