Search found 63 matches

Hello, I'm running on a 18f14k50 a test program that gets the value from Timer0 and if the value is larger or equal to 1, print a test message via UART.

main()
{
setup_timer_0(RT ...

I was just finishing reading now a other post about this and find that pgd, pgc can be only inputs , heh, even so , thank you for clearing things up once again!

Great , Thanks you all for your inputs , hope someday this will be useful to others too!

SOLVED!!!!! Setting the fuses like you did Ttelmah and not setting the setup_oscillator line did the trick..dont know exactly each one ( fuses or setup_oscillator ) was to blame but now is working! Is ...

The Compiler is 4.124 , That what is says in "Compiler Version" . I asked for the .LST to check if my compiler does the same thing like yours when it comes to setting up the Internal Oscilat ...

Thank Ttelmah for your time , unfortunately i have a not so old compiler ( Version 4.124) . You have a newer one? Other chip ( 18f25k22 ) runs just fine ..so 14k50 is the problem somehow. Can you plea ...

I have "ported" the code to a 18f25k22 for testing and is working fine with the PLL ON.....i just wish PICs were a bit more standard..still..have to make the 14k50 running..:|

Thanks Ttelmah ..i changed it but is working the same....:(

the program is here in the thread at the begining ( the fuses that i set also).
The program runs fine with 8, 16 Mhz ( NO PLL) with all baud rates.

I tried even a hardware uart now, and is working the same...did i configure the PLL wrong? ...

Hello, I`m running a 18f14k50 With the following test program:

#include <18f14k50.h>
#device adc=16
#FUSES BROWNOUT_NOSL //Brownout enabled during operation, disabled during SLEE ...

I did not set ICD, however I have a permanent MCLR pullup on my board. This could be the cause ?

Hello, I have tried this as in title, but it does not work. Is this a hardware problem? My PIC is 18F14k50. Thank you.

Thanks again jeremiah , you advices solved my problem, is working as i want now! ^**^

hmm..yea..sorry about that i did not realise that...will keep this in mind in the future..as for this one..if i had already posted it..i will go forward with it, thank you.