Search found 40 matches

OK.
First comment _USE THE CODE BUTTONS_.... Sad

Now that having been said, this was what I was puzzled by:

setup_adc_ports(NO_ANALOGS, VSS_FVR);

Pointless line. The _last_ setup_adc_po ...

Not going to download code, but what you originally posted does not
have a set_adc_channel call.
I don't think the define VSS_FVR, is for the setup_adc_ports call.
That is for using FVR as the refe ...

Download the stripped down simple code.

https://file.io/X3njzKvsLfPl

my comments

1) disable the WDT ! It's not needed until your entire program has been 100% coded/compiled and working.

- I tried with both WDT enabled and disabled.

2) The PIC.hdr file I have d ...

Can anyone please let me know whether the settings below are correct, if I want to set Pin C7 as the Analogue Input using the internal reference voltage.
I am using the internal crystal with PLL.

...

hmm... I recall some PICs cannot use the internal oscillator when run off the Pickit3. There's got to be a 'notice' about this somewhere....

@temtronic, I am using ICD-U80 debugger.

Still the issue is with debugging the micro with internal oscillator enabled and CCS have confirmed that they have simulated the fault but do not know the solution. This indicates that this might be d ...

Thanks for the help.

Port Pint B4 is behaving correctly now. It seems that the Pull Down resistor is not soldered properly. i.e. intermittent, so when I pressed with multimeter, it worked so it was ...

Download from below:-

https://file.io/CUKsblQ01uCQ

Same board works well with the code which is old Hi-Tech compiler code for the hardware. That does work and I have converted the code into CCS compiler.
Then I stripped down the code to bare minimum ...

10K is a lot smaller than recommended. Minimum recommended is 22K...
10K was the recommended value back in the ICD2 days. These were able
to drive a lower resistor.
The help for the ICD-U80 recomme ...

@tmtronic,
MAINS_IP is the low voltage input for the microprocessor and it does not get anything beyond 5V.

The hardware is fine as the old MPLAB Hi-Tech code for the board works correctly. I have ...

I have always compiled & debug with Watchdog and compiler whilst debugging, switches off the watchdog. I have used the compiler for so many micros and having trouble with this particular one.

M ...

Hi,
I have very basic code as below:-

#include <18F14K50.h>
#device ADC=10

#FUSES WDT //Watch Dog Timer
#FUSES WDT256 //Watch Dog Timer uses 1:256 ...

Thanks for your help.

The issues are in the device's .h files whereby the constants they defined do not tie up with the datasheet's register. T1_INTERNAL should turn on the Timer and place it under ...