Search found 41 matches

i did yesterday some tests,

dividing was...i was thinking the TC74 was working wit a decimal...NOT..

the TC74A5-5.0VAT is responding the correct vallue (see picture) but the controller give me ...

hello,
have someboby experience with a dspic30f6014a and i2c?
i have this project,
the processor is running over it without problem, but the result is always 0
pull up resistors are 4.7k, i see ...

hello,
Is it possible to write only the lower 8 bits to a 16 bit port (CPU is DSPIC30f6014a) ?

I want to write data to the lower 8 bits, and leave the state of the higher 8 bits at its actual sta ...

hey,
has anybody a working driver for the toshiba T6963 glcd driver, connected to portD (D0-D7 as data, D8-D11 as control bits) ?

Thanks,
Carl

Hello folks,
I have here several displays I want to use,

but which driver???

I see OKI, M5299C and M5298A ic's. The display is 256 by 128 Dots.

Thanks,
Carl

ok, i have something strange.

some code... works fine,

but after transmitting a serial character, the pic reboot

is there a solution to find out whats happening?

Carl

@ Ttelmah

hmmm. I did read this post..re-read because it is almost midnight....
changing the buffer size make sense...change to 64 : check
test and communication hangs still after +-20 seconds.
...

hello,
I have a problem with serial communication and fast interrupt.

The fast interrupt is comming from 2 encoders.

Serial communication from a pc, who is polling the pic.

When encoder is ...

problem solved.....

when i use PWM...never enable the selected timer...

Hello,
i have some strange problems,

when i set timer2 to internal, all interrupts stops working...no more timers ect...

any sugestions ?

Carl

#include <30f4013.h>
#device adc ...

still struggling with this problem... anyone plz?

that the CCS guys aren't aware of the difference, because the 0xa0 is an invalid 7-Bit address with dsPIC
correct, for this reason i am using 0x08 as address
the PCD manual is Crap (Read : A bad rew ...

What do you mean with "diffrent address coding"?
i found in the last PCd manual this :

#use I2C(slave,sda=PIN_C4,scl=PIN_C3 address=0xa0,FORCE_HW)

(Page 142, pcd manual Janua ...

can somebody tell me why this piece of code is NOT working?

#include <30f4013.h>
#device adc=12

#FUSES WDT // Watch Dog Timer
#FUSES HS
#FUSES NOCKSFSM //Clock Switching is disabled, f ...

thank for the input,
problem was in timer settings,

the correct way was :
setup_timer1(TMR_internal|TMR_DIV_BY_1,1900);

btw,
frequency i am running is :
#define XTAL_FREQUENCY ...