 |
 |
 FAQ Forum Help Official CCS Support  Search
 Register
 Profile  Log in to check your private messages  Log in
|
CCS does not monitor this forum on a regular basis. Please do not post bug reports on this forum. Send them to CCS Technical Support |
| Search found 3 matches |
| Author | Message |
|---|---|
 Topic: CAN problems |
|
| pbrew1 Replies: 18 Views: 25200 |
 Forum: General CCS C Discussion Posted: Thu Aug 17, 2006 4:12 am Subject: CAN problems |
| I used bit timing calculator and set baud to 125 kps. It now works fine. Never suspected abitrarily choosing TQ would cause problems. Why is it that when I search for "can" (on this forum) I ... | |
| Topic: CAN problems |
|
| pbrew1 Replies: 18 Views: 25200 |
Forum: General CCS C Discussion Posted: Wed Aug 16, 2006 10:13 am Subject: CAN problems |
| I build the hardware myself using TQFP44 18f458 pic
There is a 120 ohm resistor on each board next to can driver Using CCS 3.226 I was using speed set by ccs sofware, I then changed the c ... |
|
| Topic: CAN problems |
|
| pbrew1 Replies: 18 Views: 25200 |
Forum: General CCS C Discussion Posted: Tue Aug 15, 2006 10:48 pm Subject: CAN problems |
| I have two pic18f458s smd ,connected by a can network. Node#1 is just sending, node#2 is just reading. If node#2's pic is running , then node#1 stops sending(both can driver and pic). Ocasionally ... | |
All times are GMT - 6 Hours |
Powered by phpBB © 2001, 2005 phpBB Group