Search found 12 matches

Hello

I have a question about PIC Flash Memory.

What I want to do is to save some measurements to an array during my
operation.

I want to be independent of the computer serial p ...

I think noone mentioned the postscaler option of PIC timer2.

Is it because it's not applicable here? Or everyone misses it?

Postscale can (supposedly) scale the final frequency by a factor of ...

Thanks PCM Programmer Team.

I checked the Data sheet and completely understood how this works.

I didn't set the PR register in my initial code that's why I could never clear CCP output pi ...

Hello,

I am trying to start learning PWM techniques using 18F452.

The first simple task is to generate a fixed duty cycle- square wave using CCP1 pin of my PIC.

I simply use the follo ...

I removed my LCD ( it was not needed in the project ) chip,

and placed 10- LEDs instead of the LCD, I was just trying to see a correct A/D operation.

Now it works fine.

Thank you s ...

It simply locks up.

It says "animating" above but it does not nothing and I have to close it from the task manager each time.

It's not an official version, but it can simulate m ...

Is there anything terribly wrong about the following code?
I am only trying to send digital data to an LCD. MY simulation set-up uses Port B for all LCD connections ( in the correct order ), however ...

So the crystal option in Proteus is just an accessory?

In reality, the PIC will accomodate my crystal frequency, right?

The question is, is there any configurable mode of PIC that either sele ...

Hi there,

I'm having problems with the clock speed of PIC 18F452.

I configure my C code with

#fuses HS
#use delay(clock=10000000)
since I want to use a crystal of frequency 10 ...

I think you don't understand my problem.

PIC Wizard has an I/O pins section.

and I choose my selections from the list,

the "Code" tab, just next to it, shows the

cor ...

Hello,

I asked this in an earlier thread but I could not get any answers to this.

PIC Wizard of CCS V.4023 has an I/O specification tab, which presumably makes it easier to configure input, ...

Hello,

I am working on a senior design project that will use 18F452. Project will include A/D conversion at some point.

I will have relatively simple questions and I hope somebody could reply me ...