 |
 |
 FAQ Forum Help Official CCS Support  Search
 Register
 Profile  Log in to check your private messages  Log in
|
CCS does not monitor this forum on a regular basis. Please do not post bug reports on this forum. Send them to CCS Technical Support |
| Search found 3 matches |
| Author | Message |
|---|---|
 Topic: Two UART problem - one software, one hardware |
|
| tbsnake Replies: 1 Views: 5002 |
 Forum: General CCS C Discussion Posted: Sat Jul 22, 2006 1:47 pm Subject: Two UART problem - one software, one hardware |
| I am trying to use the HW uart on 18F2620 to communicate with a gps, and a SW uart to communicate with a radio. They are on different lines , c6 and c7 for HW and B4 B5 for SW.
My question pertain ... |
|
| Topic: "invert" while using uart hardware on 16f88 |
|
| tbsnake Replies: 2 Views: 9622 |
Forum: General CCS C Discussion Posted: Sat Jul 03, 2004 11:41 am Subject: "invert" while using uart hardware on 16f88 |
| Hello. Does anyone know if you can use the Uart hardware on the pic16f88 inverted:
#use rs232(baud=300,parity=N,xmit=PIN_B5,rcv=PIN_B2,bits=8,INVERT) I worry that it may bump back to software h ... |
|
| Topic: ICD0083: Target not in debug mode, unable to perform operati |
|
| tbsnake Replies: 1 Views: 7042 |
Forum: General CCS C Discussion Posted: Thu Jun 17, 2004 8:10 pm Subject: ICD0083: Target not in debug mode, unable to perform operati |
| I cant seem to debug with pic16f688, I always get the error:
ICD0083: Target not in debug mode, unable to perform operation Yet the #device ICD=TRUE command is there, and the NOP at location 0. Is t ... |
|
All times are GMT - 6 Hours |
Powered by phpBB © 2001, 2005 phpBB Group