 |
 |
 FAQ Forum Help Official CCS Support  Search
 Register
 Profile  Log in to check your private messages  Log in
|
CCS does not monitor this forum on a regular basis. Please do not post bug reports on this forum. Send them to CCS Technical Support |
| Search found 4 matches |
| Author | Message |
|---|---|
 Topic: Load n Go creates bug in my software |
|
| weev Replies: 4 Views: 40242 |
 Forum: CCS ICD / Mach X / Load-n-Go Posted: Thu Oct 11, 2012 7:00 am Subject: Load n Go creates bug in my software |
| Ok, I was actually not setting the configuration bits in CCS load because only the config table on the right side in the file tab actually sets them (if you save file afterwards).
The settings with c ... |
|
| Topic: Load n Go creates bug in my software |
|
| weev Replies: 4 Views: 40242 |
Forum: CCS ICD / Mach X / Load-n-Go Posted: Thu Oct 11, 2012 6:25 am Subject: Load n Go creates bug in my software |
| CCS load overwrites my configuration bits.
Even if I set them properly in CCS load and save the file before programming. After the programming is done, the bits are not as previously set :( |
|
| Topic: Load n Go creates bug in my software |
|
| weev Replies: 4 Views: 40242 |
Forum: CCS ICD / Mach X / Load-n-Go Posted: Thu Oct 11, 2012 5:08 am Subject: Load n Go creates bug in my software |
| Reading the pic after programming with the Load n Go and comparing it to the original hex file, I found lots of differences. | |
| Topic: Load n Go creates bug in my software |
|
| weev Replies: 4 Views: 40242 |
Forum: CCS ICD / Mach X / Load-n-Go Posted: Thu Oct 11, 2012 2:51 am Subject: Load n Go creates bug in my software |
| Dear all,
I've been using the CCS Load n Go to flash several devices / codes and until now it was working fine (with PIC24HJ64GP506) with my last design I found that programming with the Load n Go b ... |
|
All times are GMT - 6 Hours |
Powered by phpBB © 2001, 2005 phpBB Group