I need to know if somebody use this flash memory and which is your opinion?, and if know where found the code library for this.
I have another question, Is possible write only one Byte without read the page or I have to read the page (256 bytes), then modify the byte and then write the page complete.?????
Thank you very much!!
mp3fusion
Joined: 13 Dec 2004 Posts: 7
Posted: Mon Aug 01, 2005 3:08 pm
I have used the flash memory ... It is really good ... and easy to implement
If you need the driver for it ... just e-mail me at [email protected]
Shortly I am going to put it in the library ...
Farzad
mp3fusion
Joined: 13 Dec 2004 Posts: 7
consideration about voltage
Posted: Mon Aug 01, 2005 3:14 pm
I also remembered something ... the flash runs at 2.7 to 3.6 volts ...
you have to use a level shifter to change the spi flash output from 5 to 3.6
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum