CCS C Software and Maintenance Offers
FAQFAQ   FAQForum Help   FAQOfficial CCS Support   SearchSearch  RegisterRegister 

ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to CCS Technical Support
networking and PIC programming

 
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion
View previous topic :: View next topic  
Author Message
manc



Joined: 11 Jan 2011
Posts: 1
Location: IN

View user's profile Send private message AIM Address

networking and PIC programming
PostPosted: Tue Jan 11, 2011 5:42 am     Reply with quote
hi..
can some one provide me with a C code to program a PIC 18 contoller for configuring a 8 port managed layer 2 ethernet switch to be used in bandwidth/data rate limiting?
_________________
MANC
temtronic



Joined: 01 Jul 2010
Posts: 9246
Location: Greensville,Ontario

View user's profile Send private message

PostPosted: Tue Jan 11, 2011 6:23 am     Reply with quote
Show us your code attempt and we can help,include PIC type, compiler version, and all hardware used.
It is unlikely that any of the programmers here will just give you their code for free as they've spent 1,000s of hours cutting it to develop it as a commercial product for paying clients.
However, most of us will help with the quirks and gotchas IF you show us your code. Obviously small, compilable routines NOT the 5,000 lines of code in Main!
mbradley



Joined: 11 Jul 2009
Posts: 118
Location: California, USA

View user's profile Send private message Visit poster's website

PostPosted: Wed Jan 12, 2011 11:57 pm     Reply with quote
Not to be rude, but you just asked someone to hand you over an embeded application, not piece of code.

Your best route, as I believe you do not have the embeded knowledge, would be to use a linux box, with dual 4port network cards, and use bridge utilities to tie it together, then do your rateshaping with linux
_________________
Michael Bradley
www.mculabs.com
Open Drivers and Projects
Display posts from previous:   
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group