interruption

[will]

Hello
I try to make a break with two micro switches.
The program compiles fine but no detection. The LED does not light either.
why??
My program:

I put all my interruptions, see bold character

}
}[/b]

Thank you very much.

[Ttelmah]

Three things:

if (droit)==0) {

Needs to be

if (input(droit)==0) {

Second, you are not enabling INT_RB.

Third, you are 'pushing' the interrupt speed for your timer. Technically you could be interrupting about every 285 instructions. Depending on what is in 'mot_generation_pwm', you may not have any time to actually do much else.....

Best Wishes

[will]

thanks

[jeremiah]

you have an interrupt service routine setup for RB but never turn it on with enable_interrupts() like you do the other interrupt.

[will]

thank you
like this? but it does not work.

[temtronic]

You've really only shown us part of your code.
You do have a main ?

[Mike Walne]

Read the CCS forum guide.

Learn to use the code buttons.

Post a SHORT but complete compilable version of you code that we can test.

Give us some idea of your schematic.

Mike