CCS C Software and Maintenance Offers
FAQFAQ   FAQForum Help   FAQOfficial CCS Support   SearchSearch  RegisterRegister 

ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to CCS Technical Support
about serial to ethernet converter using pic18f97j60

 
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion
View previous topic :: View next topic  
Author Message
manisha



Joined: 03 Feb 2012
Posts: 29

View user's profile Send private message

about serial to ethernet converter using pic18f97j60
PostPosted: Mon Nov 25, 2013 11:52 pm     Reply with quote
Hi all,
I want to design ethernet to serial converter using inbuilt ethernet controller pic18f97j60 which I already have and I have gone through the Microchip code of PICDN2_eth97 c18 code and want to enable uart2tcpbridge which has the code of conversion. Please suggest if the ethernet to serial conversion is done using this. If so how? And also suggest for any other code...

Waiting for a reply...
asmallri



Joined: 12 Aug 2004
Posts: 1636
Location: Perth, Australia

View user's profile Send private message Send e-mail Visit poster's website

Re: about serial to ethernet converter using pic18f97j60
PostPosted: Tue Nov 26, 2013 9:52 am     Reply with quote
manisha wrote:
Hi all,
I want to design ethernet to serial converter using inbuilt ethernet controller pic18f97j60 which I already have and I have gone through the Microchip code of PICDN2_eth97 c18 code and want to enable uart2tcpbridge which has the code of conversion. Please suggest if the ethernet to serial conversion is done using this. If so how? And also suggest for any other code...

Waiting for a reply...


Well - you can use the Microchip stack with the Microchip compiler or you can use the CCS stack with the CCS compiler. If you go the Microchip compiler route then you already have the necessary code in the uart2tcpbridge.

Alternatively you you can use the CCS TCP stack and port the required functions from the Microchip TCP stack. You can do this because the Microchip license allows it as you are using with a Microchip PIC with embedded Ethernet controller meeting their licensing requirements.
_________________
Regards, Andrew

http://www.brushelectronics.com/software
Home of Ethernet, SD card and Encrypted Serial Bootloaders for PICs!!
Display posts from previous:   
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group