Hello!
I devise a communication with hearing aid via the I2c communication protocol.
Unfortunately, the manufacturer of the so-called hybrid is not stated in the datasheet addresses for communication
Can you share any ideas for accessing an unknown device Using the I2c?
Thank you!
jeremiah
Joined: 20 Jul 2010 Posts: 1358
Posted: Fri May 23, 2014 5:56 am
For starters, assuming your hardware is correct, you can scan the bus for addresses
Then see if the address matches any published for a hearing aid hybrid.
Look at the data for the EZAIRO 5910, and the SB3229 as possible ones for a start. The former in particular is often used.
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum