speed debug icd-u64

[gavilan]

Hello,

I'm using PCWHD version 5.019 with ICD-U64 and in my target there's a DSPIC33FJ256GP710. I've created a Project with "Project 24 Bit wizard". In my target I've an oscillator of 12 MHz, therefore I've configured:

Crystal clock speed: 12.000.000 Hz
CPU Clock speed: 80.000.000 Hz => 40 MIPS.

When I program in release mode the MCU runs at 80 MHz but when I program in debug mode in the debug Windows appears 7.47 MHz and I don`t know because run so slowly.

In debug mode isn't possible to run at 80 MHz?

I attached the code:

[Ttelmah]

I have a 'niggling memory' that there was a limitation at about 70MHz on the original ICD U64. Try something like 60MHz and see if this then works.