Are you using just the raw chip or a premade PCB module? I'll assume the latter as it needs a very skilled tech to design and fab a working PCB! Post the link to the module you're using as well as which PIC you think you can use.
The more information you supply the faster/better the replies you'll get.
++++++++++++++++++++++
Code block added.
- Forum Moderator
++++++++++++++++++++++
Code:
Code:
Last edited by thanhhavdt on Mon Oct 26, 2015 10:46 pm; edited 3 times in total
Ttelmah
Joined: 11 Mar 2010 Posts: 19552
Posted: Tue Oct 13, 2015 3:26 am
1) Use the code buttons.
2) Does the 'pre-made module' have a data sheet?. This is _vital_ It'll tell you/us, things like how pin 57 is wired (changes the I2C address), how the interfacing is actually done, etc. etc..
DATA
DATA
DATA
The three most important things _before_ starting a project.....
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum