CCS C Software and Maintenance Offers
FAQFAQ   FAQForum Help   FAQOfficial CCS Support   SearchSearch  RegisterRegister 

ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to CCS Technical Support
MCP41HV51 - Digital Potentiometer

 
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion
View previous topic :: View next topic  
Author Message
jjacob



Joined: 08 Mar 2008
Posts: 54
Location: PORTUGAL (PORTO)

View user's profile Send private message

MCP41HV51 - Digital Potentiometer
PostPosted: Wed Feb 15, 2017 6:28 am     Reply with quote
Hello everyone

I'm trying to do a digital potentiometer using MCP41HV51, and I want to control an VFD, from 0 to 10V.

Does someone have already a driver for this device?

Thanks for your help,

Best regards,

Jacob
Ttelmah



Joined: 11 Mar 2010
Posts: 19552

View user's profile Send private message

PostPosted: Wed Feb 15, 2017 11:56 am     Reply with quote
Don't people look at the data sheet?.

Just like in this thread:
<http://www.ccsinfo.com/forum/viewtopic.php?t=55945>

It's another device that can be directly operated without a driver.

It needs SPI mode 3. When you want the value to actually update, raise and lower WLAT. You can if you want add this to the SPI setup (#use spi supports a latch bit), or if you want the update at a specific 'time' then operate this from a timer or something similar.
PCM programmer



Joined: 06 Sep 2003
Posts: 21708

View user's profile Send private message

PostPosted: Wed Feb 15, 2017 1:05 pm     Reply with quote
According to the MCP41HV51 data sheet, it will also operate in SPI Mode 0:
Quote:
6.2 The SPI Modes
The SPI module supports two (of the four) standard SPI
modes. These are Mode 0,0 and 1,1. The mode is
determined by the state of the SDI pin on the rising
edge of the first clock bit (of the 8-bit byte).

http://ww1.microchip.com/downloads/en/DeviceDoc/20005207B.pdf
Ttelmah



Joined: 11 Mar 2010
Posts: 19552

View user's profile Send private message

PostPosted: Wed Feb 15, 2017 1:19 pm     Reply with quote
Yes. A lot of things support both these modes. Their diagram shows the idle clock as high, so I felt it best to keep it simple and match the diagram. Very Happy
Display posts from previous:   
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group