CCS C Software and Maintenance Offers
FAQFAQ   FAQForum Help   FAQOfficial CCS Support   SearchSearch  RegisterRegister 

ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to CCS Technical Support
A simple interrupt question

 
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion
View previous topic :: View next topic  
Author Message
PappasTech
Guest
A simple interrupt question
PostPosted: Sat Aug 29, 2009 11:15 pm     Reply with quote
So I've been searching this forum for a while, but all I see anyone using to setup interrupts is 'enable_interrupt(GLOBAL)'. What if, for example, I just want a state change of pin A4 on a 16f688 PIC to trigger an interrupt? Is there some specific code to do this or should interrupts simply be enabled globally?

Thanks,
Tom
PCM programmer



Joined: 06 Sep 2003
Posts: 21708

View user's profile Send private message

PostPosted: Sun Aug 30, 2009 12:06 am     Reply with quote
Quote:

What if, for example, I just want a state change of pin A4 on a 16f688
PIC to trigger an interrupt

See the sample code near the end of this thread:
http://www.ccsinfo.com/forum/viewtopic.php?t=39835
Display posts from previous:   
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group