I am struggling with this modules. Sadly I lost the good code due to HD crash. According to PDF from the manufacturer this should be good setup for SPI
I'm not using the HopeRF modules, but I can confirm, that SPI Mode 0, as sel in your use_spi() statement is correct according to the manufacturer datasheet. Also SPI speed should no problem, because the chip works up to 20 MHz. So either a hardware problem or incorrect SPI command format should be expected.
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum