CCS :: View topic - 18F87K22 CCP2 problem. Resolved!!!

FAQ

Forum Help

Official CCS Support

Profile Log in to check your private messages Log in

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to CCS Technical Support

18F87K22 CCP2 problem. Resolved!!!
Goto page Previous 1, 2

CCS Forum Index -> General CCS C Discussion

View previous topic :: View next topic

Author

Message

w2drz

Joined: 27 Dec 2006
Posts: 55
Location: Western New York - USA

Re: Resolved!!!!!!!

Posted: Sun Mar 04, 2012 11:34 pm

curt2go wrote:

Well after alot more reading about the SOSC it shows in that you MUST!!! tell the fuse that you would like the RC0 and RC1 to be digital IO.. This can not be done by setting TRIS... so you must use the

#FUSE SOSC_DIG

Would have liked my 10 hours back!!! Smile

BUt its resolved now...

Hi,
Was also caught with same FUSE on the K80 chip when first used that chip.
If a secondary oscillator is not desired and digital I/O on
port pins, RC0 and RC1, is needed, the SOSCSEL bits
must be set to Digital mode.
USE FUSE 'SOSC_DIG' to set the I/O for C0 & C1 to digital

TGM W2DRZ

Display posts from previous:

	CCS Forum Index -> General CCS C Discussion	All times are GMT - 6 Hours Goto page Previous 1, 2
Page 2 of 2

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum