18F4620 & ICD-U Problem

cfernandez · Joined: 18 Oct 2003 Posts: 145

Hi,

I have a problem when write my program or when blank chip.

The message of the ICD Verifacation Result Window is the following.

Actual Data (HEX) 00 07 1F 1F 00 83 85 00 0F C0 0F E0 0F 40

Expected Data (HEX) 00 02 1F 1F 00 83 85 00 0F C0 0F E0 0F 40

I have connect the ICD-U programer to VCC, VSS, RB6, RB7 and MCLR signal or another signal is needed.?

1) Somebody use this PIC with ICD-U & CCS?
2) Can you send me the schematics for ICSP?
3) Which are the correct fuses for this PIC?

I wait for your help!!

Thank you very much!!

Best Regards,

libor · Joined: 14 Dec 2004 Posts: 288 Location: Hungary

You might have the same problem as we had with the similar 18F2620 posted here

cfernandez · Joined: 18 Oct 2003 Posts: 145

Dear Libor,

With the new version of ICD firmware 1.35 can you load the program ok?.

You have the new firmware?, can you send me to my email [email protected]?

thank you very much!!

cfernandez · Joined: 18 Oct 2003 Posts: 145

The CCS SUpport send me the ICD-U firmware 1.37 and with this not have the error verification.

Thank