CCS C Software and Maintenance Offers
FAQFAQ   FAQForum Help   FAQOfficial CCS Support   SearchSearch  RegisterRegister 

ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to CCS Technical Support
Need source code for interfacing with ENC28J60 Ethernet Chip

 
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion
View previous topic :: View next topic  
Author Message
overdose_rc



Joined: 18 Oct 2005
Posts: 1
Location: Malaysia

View user's profile Send private message Send e-mail Yahoo Messenger

Need source code for interfacing with ENC28J60 Ethernet Chip
PostPosted: Tue Oct 18, 2005 4:34 pm     Reply with quote
Anyone had a pic source code for interfacing with ENC28J60 Ethernet Chip???
valemike
Guest
PostPosted: Tue Oct 18, 2005 5:00 pm     Reply with quote
Perhaps when you're done writing it, you can post it in the shared code forum.
asmallri



Joined: 12 Aug 2004
Posts: 1636
Location: Perth, Australia

View user's profile Send private message Send e-mail Visit poster's website

PostPosted: Tue Oct 18, 2005 6:28 pm     Reply with quote
CCS have a port of Microchip stack available for the Realtek controller. To support the ENC controller the MAC.C and MAC.H modules need to be replaced by versions of Microchip's ENC28J60.C and ENC28J60.H modules.

I have written my own CCS equivalent of the ENC28J60 MAC drivers but it in not in the same format as Microchip's because I use my own stack. However it would be possible to take the code and put it in the required format. Unfortunately I don't have the time at the moment to do this.

When do you need it?
_________________
Regards, Andrew

http://www.brushelectronics.com/software
Home of Ethernet, SD card and Encrypted Serial Bootloaders for PICs!!
Display posts from previous:   
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group