CCS C Software and Maintenance Offers
FAQFAQ   FAQForum Help   FAQOfficial CCS Support   SearchSearch  RegisterRegister 

ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to CCS Technical Support
Serial comm baud 57600
Goto page Previous  1, 2
 
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion
View previous topic :: View next topic  
Author Message
Vefa



Joined: 13 Feb 2007
Posts: 9

View user's profile Send private message

PostPosted: Tue Feb 13, 2007 3:27 pm     Reply with quote
The link to the data sheet of the IMU is:
http://www.sparkfun.com/datasheets/Sensors/IMU_6DOF-v21.pdf

Thanks,
Guest
PostPosted: Tue Feb 13, 2007 3:45 pm     Reply with quote
Not exactly a data sheet. More a product overview...
How are you connecting to this?. If you are connecting via the 'debug header' to the PIC, then you do not need any Max chip. The connections here are TTL serial, which will connect directly to the PIC. Adding a MAX232 or similar, will result in a signal inversion, and more voltage being put into the unit, than it is designed to take...

Best Wishes
Vefa



Joined: 13 Feb 2007
Posts: 9

View user's profile Send private message

works!!
PostPosted: Wed Feb 14, 2007 1:05 pm     Reply with quote
You are right. I've just connected the IMU output directly to C6, C7 instead of passing thru MAX235 and it works.

Thanks all,
Display posts from previous:   
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion All times are GMT - 6 Hours
Goto page Previous  1, 2
Page 2 of 2

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group